Steps to changing automatic tranmission fluid.

-
The level of your car's automatic transmission fluid ( ATF) should be checked every morning and topped if need be. ATF should be changed according to the millage specification by the car's manufacturer. Some manufacturers demand you to change it in every 30,000 miles.

While changing your ATF your self, the following steps should be be followed;
1. Drive the car around to make the fluid hot and less viscous.
2. Jack the car and support it with axle stands. Never go under a car that is not supported with axle stands, it can cost you a lot.
3. Unscrew the drain plug under the gear box and drain the ATF.
4. Screw the drain plug back
5. Open the hood.
6. look for where the dipstick for the ATF is located. This is for honda cars and some Toyota.
7. Remove the dipstick.
8. Fill your oil gun with the ATF.

9. Use the gun to fill the gearbox via the hole for the dipstick.
10. constantly check the gauge of the ATF.
 

Comments

Post a Comment

Popular posts from this blog

Brake pad wear indicator

-
Image
The brake is one of the most important safety/ operational part of the vehicle, therefore car manufacturers have put so many measures in place to determine when the brake pad is due for a change. Mind you, the brake pad is made of materials that wear off easily in other to make the brake rotor (disc), which is more expensive, not to wear off easily while in braking and also to reduce energy loss due to heat caused by friction (We will talk about the essence of brake pads and brake pad materials in our teaching). So if you have a brake pad that doesn't wear off then you bought yourself a damaging tool. Here are the different brake wear indicators on an automobile: 1. Ocular brake indicator: this are grooves made on the brake pad. One must constantly check the brake pads to know when the brake pads flattens with the grove. 2. Mechanical metal plate indicator: A metal plate is attached on some brake pads so that when the brake is due for change the plate can touch the surface of the d...
Read more

How to detect faulty brake sensors on a range rover

-
Image
Brake lights are been turned up on the dash board whenever the brake pads wears to an unbearable level or sometimes when the sensor become faulty. so when you see a break light pop up, don't get weary it might just be that the fluids are very low.. First check the brake fluid level, then check the level of your brake pad and see if it needs to be change.  Range rover has two brake pad sensors, one in the front- left tyre and the other one in the rear right tyre.                                            Steps to detecting a faulty sensor Trace the brake sensor wire from where it fits into the brake pad upwards to a junction box close to the wish bone. Open the junction box, be careful not to tamper with the ABS sensor. Disconnect the brake sensor wire. ...
Read more

How to change dashboard instrument cluster

-
Image
Replacing a speed clock . The speed clock of a vehicle is like a google map in the hands of a first timer in an area. The speed clock tells you how fast your car is moving, it tells you the level of fuel you have left in the tank, it even tells you about the condition of the engine and many more. So the speed clock is something that you must have working. Steps to replacing the speed clock 1. Remove the positive terminal on the battery head. 2. Press the steering release lever to lower the steering. 3. Unscrew the bolts on the trim bezel and pull out the trim bezel (dashboard display cover). 4. Unscrew the bolts holding the dashboard display and wiggle it out. 5. Remove the socket at the back of the dashboard display. 6. Fix the new display, don't forget to socket the wire at the back of the display. 7. Fasten back the bolts and put back the cover. 8. Fix back the positive terminal of the battery. And you are good to go. Tools for the work Philip screw driver Flat...
Read more